O2 Sensor Dynamic Parameter Names

1K Views
Last Post 16 September 2017

iGitErDone posted this 11 September 2017

The names displayed in my OBD Car Doctor Free app are obscure and confusing. I suggest changing these names as follows:

Bank 1, Sensor 2V
- Change to Bank 1, Sensor 2 - O2 Sensor - Volts
Bank 1, Sensor 2%
- Change to Bank 1, Sensor 2 - O2 Sensor - Percent
Bank 2, Sensor 2V
- Change to Bank 2, Sensor 2 - O2 Sensor - Volts
Bank 2, Sensor 2%
- Change to Bank 2, Sensor 2 - O2 Sensor - Percent
O2S1_WR_Lambda Ratio
- Change to Bank 1, Sensor 1 - F/A Sensor - Lambda Ratio
O2S1_WR_Lambda I
- Change to Bank 1, Sensor 1 - F/A Sensor - Current
O2S5_WR_Lambda Ratio
- Change to Bank 2, Sensor 1 - F/A Sensor - Lambda Ratio
O2S5_WR_Lambda I
- Change to Bank 2, Sensor 1 - F/A Sensor - Current

The above parameters are displayed by the app because my car has Fuel/Air ratio sensors upstream. Otherwise, I suppose the app would display Oxygen sensor parameters for Sensor 1 similar to the Sensor 2 parameters above.

Also, there was no data displayed by the app for the Sensor 2 Percent parameters.

3 Comments

Order By: Standard | Newest | Votes

Admin

inCarDoc posted this 13 September 2017

Thank you for the feedback!

We will try to change names of sensors and parameters to more readable according to your recommendations. The only issue that names remains quite long and might be hardly readable at some screens... If any ideas of short-and-readable description, it would be fantastic!

Admin

inCarDoc posted this 13 September 2017

Also, there was no data displayed by the app for the Sensor 2 Percent parameters.

The most possible reason is just absence of the parameter data in ECU response. According to OBD-II, both Volts and Percentage are packed as one parameter, so it's impossible to "hide" not supported parameter before reading the exact response stream.

Thanks!

iGitErDone posted this 16 September 2017

What confused me most was the apparent lack of Bank 1 Sensor data in the parameter list. So I think the parameter name should clearly identify the Bank and Sensor. I also think the name should identify the type of sensor, ie. Oxygen or Fuel/Air ratio. I tried to do this in the names I suggested above. I understand you need compact names for the displays so here is my attempt at that: