Is it possible to read errors from other systems: ABS, automatic transmission, etc.
In accordance with the OBD-II only Check Engine errors are displayed and reset, i.e. engine and transmission errors.
*To clear errors one should do it with the engine stopped, but the power switched on.
The errors from other systems (i.e. ABS, automatic transmission, SRS (Airbag), etc.) do not described by the OBD-II standard, so it is not supported by the application.
You can mostly through on board diagnostic connector 2 (obd2) extract any information from any modul
Please don't mixup the diagnostic connector and OBD-II standard. Standard give exact requirements for mechanical connector part (socket), electrical part (signal layer), and protocol (logical layer). And all this describes ONLY engine (and bit around) related cases. Nobody reject the fact that OTHER car system could use the same mechanical and electrical parts of protocol for the communication, but that is NOT anyway regulated by the standard... and not supported with our program. Thank you for the attention.
Ok I was an ASE certified mechanic for 20 years and any basic scan tool will get abs but not others so you are wrong so please give out good info not this push you off crap
Ok I was an ASE certified mechanic for 20 years and any basic scan tool will get abs but not others so you are wrong so please give out good info not this push you off crap
Expected that certified specialist should operate with terms of exact standard or guide reference (not only with terms like "every basic scan tool"), that setup rules and regulate readings of requested parameters. Please point exact reference and or paragraph of OBD-II standard specification that regulates universal protocols of reading ABS.
For sure you could reject our expertise and do your own investigation with keywords ABS OBD-II ELM327, If you are right, it's expected to find out a lot of applications, solutions and recipes of reading ABS with ELM327 in a unified way for any make/model/year.
Thank you for being precise in your comments!
Subaru impereza wrx 2.0 manual turbo 5 speed year 2004 uero spec
Is it possible to read errors from other systems: ABS, automatic transmission, etc.
In accordance with the OBD-II only Check Engine errors are displayed and reset, i.e. engine and transmission errors.
*To clear errors one should do it with the engine stopped, but the power switched on.
The errors from other systems (i.e. ABS, automatic transmission, SRS (Airbag), etc.) do not described by the OBD-II standard, so it is not supported by the application.
